Make your equipment run up to 7 X longer with clean oil.
With oil analysis you can independently identify the condition of your lubricant and set yourselves targets to improve the fluid cleanliness with filtration suppliers.
Particle counts can vary dramatically between manufacturers and methods, so to ensure you are comparing two filter suppliers fairly then use a laboratory dilution particle counting analysis rather than basic on site particle counters.
The table below shows the potential improvements that can be gained in equipment life from improved cleanliness.
Test your knowledge on Particle counting below.
0 of 2 questions completed
Quiz about ISO cleanliness
You have already completed the quiz before. Hence you can not start it again.
Quiz is loading...
You must sign in or sign up to start the quiz.
You have to finish following quiz, to start this quiz:
0 of 2 questions answered correctly
Time has elapsed
You have reached 0 of 0 points, (0)
|Table is loading|
|No data available|
Question 1 of 2
1. Question1 points
For a new hydraulic oil what is a typical ISO cleanliness code when measured by laser.Correct
Question 2 of 2
2. Question1 points
Which method will usually provide lower particle counts on oils than other methods?Correct